Skip to main content
Version: 2.0.0

Setting the Open Files Limit

When the casper-node launches, it tries to set the maximum open files limit (nofile) for the process to 64000. With some systems, this limit will be larger than the default hard limit of 4096.

The node software uses file handles for both files and network connections. Since network connections are unpredictable, running out of file handles can stop critical file writes from occurring. Therefore, the default nofile limit needs to be increased.

With the casper-node-launcher running, you can see what the system allocated by finding the process ID (PID) for the casper-node with the following command.

pgrep "casper-node$"
Sample output
$ pgrep "casper-node$"
275928
note

This PID will change, so you need to run the above command to get the current version with your system. Also, it will not be 275928 each time.

If you do not get a value in return, you do not have the casper-node-launcher running correctly.

To find the current nofile (number of open files) hard limit, run prlimit with the PID from the previous command:

sudo prlimit -n -p <PID>
Sample output
$ sudo prlimit -n -p 275928
RESOURCE DESCRIPTION SOFT HARD UNITS
NOFILE max number of open files 1024 4096 files

You can also embed both commands as shown here:

sudo prlimit -n -p $(pgrep "casper-node$")
Sample output
$ sudo prlimit -n -p $(pgrep "casper-node$")
RESOURCE DESCRIPTION SOFT HARD UNITS
NOFILE max number of open files 1024 4096 files

If you receive prlimit: option requires an argument -- 'p', then pgrep "casper-node$" is not returning anything because the casper-node-launcher is no longer running.

Setting the Limit Manually

Run the command below to set the nofile limit for an active process without restarting the casper-node-launcher and casper-node processes. Note that this setting is active only while the casper-node process runs. To make this setting permanent, update the limits.conf file instead.

sudo prlimit --nofile=64000 --pid=$(pgrep "casper-node$")`

Next, check that the prlimit has changed:

sudo prlimit -n -p $(pgrep "casper-node$")
Sample output
$ sudo prlimit -n -p $(pgrep "casper-node$")
RESOURCE DESCRIPTION SOFT HARD UNITS
NOFILE max number of open files 64000 64000 files

Updating the limits.conf File

It is possible to persist the nofile limit across server reboots, casper-node-launcher restarts, and protocol upgrades, by adding the nofile setting for the casper user in /etc/security/limits.conf.

Add the following row to the bottom of the /etc/security/limits.conf file:

casper          hard    nofile          64000

Afterward, log out of any shells to enable this change. Restarting the node should maintain the correct nofile setting.